Kit Contents
- (1) The module
- (2) The extension sd to micro sd (side raspPi) (25cm)
- (3) The extension sd to micro sd (side printer) (40cm)
- (4) Micro sd adapter to usb côté (side raspPi)
prerequisites
STL files: thingiverse
please print the following files:
- minimal case part A
- minimal case part B
- minimal case part C
Assembly
Please turn off your PI before assembly.
Connect the shortest extension on RaspPi
Warning the extension should be connected upside down, a logo is present on the black part to indicate the meaning (the logo should not be visible as in the picture below)
Note: the part B must be pressed as in the picture with the notch facing you
the part C must be slipped on the part A and partly cover the part B
Once done, you can connect the module to the raspberry (off)
Warning: we recommend to turn on the PI to check that you have correctly connected the card (at least one led must be lit on the card, if this is not the case, it is that you with offset the map, verify your connection). IF everything is good, turn off the PI again.
then :
- (1) connect the 40 cm extension to the "printer" extension of the module (this extension must be connected to the micro sd port of your printer)
- (2) connect the microsd adapter to usb
then plug the micro SD adapter to USB on the raspberry
Warning, the adapter must always be connected to the extender before being connected to the usb of the pi, in case of disconnection of the extension you will have to disconnect the adapter of the usb of the PI, connected the extension to this one and then reconnect it to the pi.
you can now turn on your PI, and do not forget to connect the second extension to your printer